Page 1 of 1

Forced factory default restore

PostPosted: Sun Aug 10, 2014 12:02 am
by jye1
Sometimes DSO068 might be found behaviors abnormally (like constantly rebooting, halt in a specific state) and menu can't be entered to perform factory default restoration. In this case you can do forced factory default restore by following steps below:

1 ) Power off the scope and connect PF6 pin at J6 to GND via a 1K resister.
2 ) Power up device to normal working state.
3 ) Power off device and removed the connection made in 1 ).

Re: Forced factory default restore

PostPosted: Sun Oct 25, 2015 1:28 pm
by Clint
When I look at my board, and schematic, I see PF6 on J7, not J6. Should that be J7?

Re: Forced factory default restore

PostPosted: Tue Oct 27, 2015 2:29 pm
by jye1
Yes PF6 is on J7 instead of J6. Sorry for the mistake.

Re: Forced factory default restore

PostPosted: Tue Oct 27, 2015 2:54 pm
by Clint
Thanks. Worked great.