Forced factory default restore

Anything about this unique oscilloscope DIY kit

Forced factory default restore

Postby jye1 » Sun Aug 10, 2014 12:02 am

Sometimes DSO068 might be found behaviors abnormally (like constantly rebooting, halt in a specific state) and menu can't be entered to perform factory default restoration. In this case you can do forced factory default restore by following steps below:

1 ) Power off the scope and connect PF6 pin at J6 to GND via a 1K resister.
2 ) Power up device to normal working state.
3 ) Power off device and removed the connection made in 1 ).
jye1
 
Posts: 927
Joined: Wed Feb 20, 2013 4:58 pm

Re: Forced factory default restore

Postby Clint » Sun Oct 25, 2015 1:28 pm

When I look at my board, and schematic, I see PF6 on J7, not J6. Should that be J7?
Clint
 
Posts: 2
Joined: Sat Oct 24, 2015 11:42 pm

Re: Forced factory default restore

Postby jye1 » Tue Oct 27, 2015 2:29 pm

Yes PF6 is on J7 instead of J6. Sorry for the mistake.
jye1
 
Posts: 927
Joined: Wed Feb 20, 2013 4:58 pm

Re: Forced factory default restore

Postby Clint » Tue Oct 27, 2015 2:54 pm

Thanks. Worked great.
Clint
 
Posts: 2
Joined: Sat Oct 24, 2015 11:42 pm


Return to DSO 068

Who is online

Users browsing this forum: No registered users and 3 guests