DSO096 has similar structure as DSO062 but its performance has been significantly improved. Comparing to 062 DSO 096 bandwidth is 5 times wider
(5M vs 1M) and sensitivity is 10 times higher (10mV vs 0.1V). Particularly, its frequency meter has been greatly enhanced. It can measure frequency
higher than 20MHz at sensitivity better than 0.2Vpp (062 can only take 5 - 6 MHz signal and requires TTL level). Another big improvement is that DSO096 is
battery-powered. Accepted voltage ranges from 2V to 5V so one regular 3.7V Li-ion or two 1.2V Ni-HM batteries can be used. It also comes with a built-in charger
specific for 3.7V li-ion battery.
DSO 096 has built-in USB-Uart converter which easy-off firmware upgrade and waveform upload. It can also run on USB power without battery.
All DSO 096 models include a standard 10X/1X switchable
BNC probe.
Features
20MHz frequency meter with better than 0.2Vpp sensitivity @20MHz.
5MHz analog bandwidth and higher
2Msps real-time sampling rate
20Msps Equivalent-Time Sampling rate (repetitive signal)
Vertical sensitivity 10mV/Div - 5V/Div
Record length 256 points
Trigger position adjustable and trig point indicated
Save/Recall up to 6 captures
Screen image hardcopy via USB
Firmware upgradable via USB
FFT with selectable length of 256 or 512 points and sampling rate from 1KSps to 2MSps
Battery/USB powered with voltage ranges from 2V - 5V
Dimension: 140mm X 65mm X 25mm
Weight: 150 gram (not including probe and battery)
Ordering Info
Sku Number
Contents
One DSO096 oscilloscope
One BNC probe (20MHz, 1x and 10x switchable)
[photo]
One battery cable with connector (no battery)
Quick Use Guide (English)
One DSO096 oscilloscope
One BNC probe (20MHz, 1x and 10x switchable)
[photo]
One Li-ion battery, 3.7V, 1200mAh
Quick Use Guide (English)
Documents, firmwares, and tools:
Specification
Vertical
Number of Channel: One
Analog Bandwidth: 0 - 5MHz
Sensitivity: 10mV/Div -- 5V/Div
Resolution: 8-bit
Input Impedance: 1M ohm/25pF
Maximum Input voltage: 50Vpk (for 1X probe)
Coupling: DC, AC, GND
Horizontal
Max Real-time Sampling Rate: 2MSps
Max Equivalent-Time Sampling Rate (hardware): 20MSps
Timebase: 0.5us/Div - 10min/Div
Record Length: 256 points
Run/Hold Modes: one button switchable
Trigger
Trigger Modes: Auto, Normal, Single
Trigger Types: Rising/falling edge
Trigger Sources: Internal only
Trigger Position: Adjustable
Trig Point Indicator: Yes
Other Features
Save/Recall up to 6 captures
Screen image hardcopy
USB connection for data transfer and firmware upgrade
FFT with selectable length of 256 or 512 points and sampling rate from 1KSps to 2MSps
Display
2-inch 128 X 64 black-and-white dot-matrix LCD
Backlight ON/OFF control
Contrast adjustable
Power Supply
3.7V Li-ion battery/USB
Supply voltage range: 2 - 5V
Supply Current: 210mA @ 3.7V(LCD backlight ON, typical). 150mA @ 3.7V(LCD backlight OFF, typical)
Battery over-discharge protected
Physical
Dimension: 140mm X 65mm X 25mm
Weight: 150 gram (not including probe and battery)